Flax Packing with Grease Manufacturers

Every single member from our large efficiency profits team values customers' requirements and organization communication for Flax Packing with Grease, In addition, we would properly guideline the shoppers about the application techniques to adopt our products and solutions as well as the way to select appropriate materials.
Flax Packing with Grease, With well educated, innovative and energetic staff, we are responsible for all elements of research, design, manufacture, sale and distribution. By studying and developing new techniques, we are not only following but also leading fashion industry. We listen attentively to the feedback from our customers and provide instant replies. You will instantly feel our professional and attentive service.

Hot Products

  • Packing 4 Rolls Calender

    Packing 4 Rolls Calender

    Packing 4 rolls Calender, For shaping the finished braiding packing. We normal offer you 12 sets mould, the detailed size is up to you.
  • 18 Carrier Square Braider with 3 Orbits

    18 Carrier Square Braider with 3 Orbits

    18 Carrier Square Braider with 3 Orbits a universal square braider, for braiding fiber packing with size 6 ~ 16mm square
  • Joint Wrap Tape

    Joint Wrap Tape

    Joint Wrap Tape is used as thebase material which is coated by the liquid butyl rubber film, both of which are pressed and compounded. Usually its pe film is thinner than the one of nti-corrosion tape while the adhesive layer is much thicker. Joint wrap is used on pipe joints,fabrications,bends,fittings and tie bars.
  • Asbestos Rubber Sheets

    Asbestos Rubber Sheets

    Asbestos Rubber Sheets Made of asbestos Fibre, rubber and heat-resisting packing material, compressing it to thick paper .
  • PTFE Fittings

    PTFE Fittings

    Kaxite is one of the leading China PTFE Fittings suppliers and manufacturers, and with productive factory, welcome to wholesale PTFE Fittings products from us.
  • Aramid Fiber Packing

    Aramid Fiber Packing

    Aramid fiber packing braided from high quality Dupont aramid and kevlar fiber with PTFE impregnated and lubricant additive. It is wear resistant but may damage the shaft is not used properly. A minimum shaft hardness of 60HRC is therefore recommended.

Send Inquiry