Kaxite B400C Rubber Sheet Reinforced with Cloth is a fabric inserted rubber sheet produced by calendering a B400 rubber compound with one or more layers of cotton, nylon, EP, polyester or steel wire mesh. The cloth insertion raises tensile strength, limits deformation under load and improves dimensional stability, making the sheet suitable for punching gaskets and seals and for making lightweight conveyor belts. Supplied in 1.0-150 mm thickness, up to 4.0 m width, with wholesale quantity, custom color, OEM labeling and free samples available.
Kaxite Rubber Sheet Reinforced with Cloth is a calendered rubber sheet with one or more woven fabric layers bonded inside the compound. The fabric insertion carries the mechanical load, so the sheet resists stretching, permanent deformation and edge curling far better than a plain rubber sheet of the same hardness. It is supplied as a full roll for in-house punching or as cut strips and pads, and it is used to coin gaskets, seals, anti-vibration pads and lightweight conveyor belts.
Without fabric, a soft rubber sheet creeps under continuous bolt load and the gasket line loses compression. The cloth layer locks the sheet dimensionally, so sealing force stays consistent over the service life.
The reinforced structure punches, dies and shears cleanly. Flange gaskets, washers and pads come out flat and dimensional, reducing scrap on high-speed cutting lines.
Cotton for general sealing, nylon for higher strength, EP and polyester for wet or oil-exposed service, steel or copper wire mesh for the heaviest mechanical loads — selectable on the same order.
Natural rubber, SBR, NBR, neoprene, EPDM, silicone and fluorine rubber compounds can all be supplied in reinforced form, so the chemical and temperature rating is not limited by the insertion.
Sheet thickness from 1.0 mm to 150 mm, standard roll width from 1.0 m to 2.0 m and up to 4.0 m on request, plus custom colors and roll lengths — a single purchase order can cover the full specification.
As a China-based cloth inserted rubber sheet manufacturer, Kaxite supports wholesale rolls, punching and die-cutting to drawing, private label packing, TDS download and free samples for qualification testing.
The most economical option. Suitable for general-purpose gaskets, washers and pads where chemical exposure is mild and mechanical load is moderate.
Higher tensile strength than cotton with better fatigue resistance. Preferred where the sheet is die-cut into repeated shapes or used in dynamic pad applications.
Better wet strength and resistance to oils and mild chemicals than cotton. Common in industrial sealing and light conveyor belt fabrication.
The heaviest mechanical reinforcement. Used where the sheet must resist high bolt loads, edge tearing or mechanical abrasion without failure.
Provides electrical and thermal conductivity alongside the mechanical reinforcement. Used in specialty sealing and electrical insulation interfaces.
Two or three fabric plies for maximum stiffness and dimensional stability. Selected where the sheet is used as a structural separator or heavy-load pad.
Punched into full-face and ring gaskets where the sheet must hold bolt load without creeping or extruding.
Fabric insertion provides the strength layer in low-load conveyor belting for food, packaging and light industrial lines.
Cut into pads for machinery feet, compressors and pumps where a firm but slightly resilient footing is required.
Used in cabin trim, seals and mounting interfaces where dimensionally stable rubber sheet is needed.
Deck pads, hatch seals and structural isolation layers where repeated bolt load and water exposure coexist.
Insulating pads and mounting sheets where a controlled dielectric and mechanical performance is specified.
Send us the thickness, width, roll length, rubber compound, insertion material and quantity. We reply within 24 hours with FOB price, lead time and a free sample offer for qualified buyers.
